HyperNext Studio > Getting Started

^ Invalid Source when trying to run "Hello World"

(1/1)

Ericthered:
I'm having a pretty basic problem. In the "Hello World" tutorial, I keep getting an error message after I close the editor and attempt a run. The error is ^ invalid source

As far as I know, I have installed everything properly. Any thoughts as to the problem will be appreciated.

Eric the Red.

tigabyte:
Hi Eric

I assume the Editor opens again and gives the error message.
If so, it sounds like a spelling mistake and the complier cannot understand the command you entered.

The command should be Message 'Hello World'

Note, there should be single quotes around Hello World

I hope this helps.

Malkom

Navigation

[0] Message Index