Author Topic: Lightstone problem  (Read 4690 times)


  • Newbie
  • *
  • Posts: 49
Lightstone problem
« on: July 01, 2010, 10:40:31 AM »
I have W. Vista Basic and executed the HyperNext player software. i
don't know why, but when I open the Lightstone stack I have one device
connected to my PC), I cannot make it to work.

Here is a screeenshot.

Am I doing something wrong?
« Last Edit: January 01, 1970, 01:00:00 AM by Guest »


  • Administrator
  • Newbie
  • *****
  • Posts: 430
  • Here to help you
Re: Lightstone problem
« Reply #1 on: July 01, 2010, 10:41:22 AM »
Thank you for the info on your HyperNext Lightstone problem.

I have tested LS on Windows Vista and it did work reliably.

Perhaps you can install HyperNext Studio - and load the Lightstone project into HyperNext Creator - then you could put some debug messages into the scripts to see where it is going wrong. Knowing the values of "devNumber" as used in the "Get Device" and "Connect" buttons would be helpful.

According to your screen shot - HyperNext is attached to your Lightstone but the internal device number used by HyperNext appears to be zero.

Have you tried a USB utility to probe your ports and determine that you are using the correct hex vendor ID number etc?
« Last Edit: January 01, 1970, 01:00:00 AM by Guest »
I am sorry but I do not have time to answer questions by PM or email.
If you post your questions in this forum then it might help others.